4-leg-Rack-bill-of-materials

North Carolina State University -- Department of Biological & Agricultural Engineering Revised: 7-14-05

Four Leg Burley Curing Rack  
Multi-Level Bill of Material








  Part Name/Description Part No. Drawing No. Rev. Material Code Purchase Information Qty. Of Material Units Cost Per Unit Qty. Of Units  Sub-Total
  Four Leg Burley Curing Rack R8 R8                
                       
  Frame Sides and Ends       Lumber 2 x 6 by 12 feet 3 pieces 9.00 3 27.00
  Center Joists       Lumber 2 x 4 by 12 feet 1 pieces 6.50 1 6.50
  Joist Hangers       Galvanized Sheet steel   4 pieces 0.50 4 2.00
  Concrete Reinforcing Wire       Steel Wire Mesh 6" x 6" Grid, 10 Gage by 60" Wide 12 ft 9.46 1 9.46
  Nails       Galvanized Wire Nails 12d 16 pieces 0.02 16 0.32
  Fence Staples         1-3/4" long by 9 Ga. 44 pieces 0.02 44 0.88
                       
  Corner Bracket Assembly R1 R1a, R1b 7/11/2005              
  3" x 3" Plate With Hole R2 R2 7/11/2005 1/4" x 3" Flat Stock   0.25 ft 0.89 4 3.56
  5" x 5" Bottom Plate R3 R3 7/11/2005 1/4" x 5" Flat Stock   0.42 ft 0.91 4 3.64
  Side Plate R6 R6 7/11/2005 1/4" x 5" Flat Stock   1 ft 2.17 8 17.36
  Carriage Bolts       Plated Steel 1/2" by 2-1/2 long 24 pieces 0.25 24 6.00
                       
  Leg Assembly R9 R9 7/12/2005              
  1 1/4" Untested Black Iron Pipe R4 R4 7/11/2005 1 1/4" Pipe   7 ft 11.06 4 44.24
  3" x 3" Leg Base R5 R5 7/11/2005 1/4" x 3" Flat Stock   0.25 ft 0.89 4 3.56
  3" x 3" Plate With Hole R2 R2 7/11/2005 1/4" x 3" Flat Stock   0.25 ft 0.89 4 3.56
  Linch Pin (For Tubes) R7 R7 7/12/2005 7/16"   1 piece 1.09 4 1.09
                    Total 129.17